What to Look Out For and How to Fix Blocked Toilets

3 minutes, 36 seconds Read

Blocked toilets are a common problem for many people, so it’s important to know what to look out for and how to fix them.

If your toilet flushes slowly, or the water level drops after you flush it, it’s a sure sign that you have a blockage somewhere in your plumbing system.

Bad Odours

Toilets can smell bad for a variety of reasons. It can be due to a simple clog or something much more serious.

Bacteria is a common culprit for sewage odours. It can build up in your drain system over time if you don’t keep it cleaned and clear.

A broken wax seal ring is another problem that can lead to sewer odours. This ring sits between your toilet and a sewer line, keeping the odors from entering your home.

When the ring becomes worn or breaks, sewer gas can seep through and cause a foul odor.

Often, this can be caused by things like a faulty wax ring or too much use of the plunger.

Other issues that can cause foul odours include a blocked toilet vent pipe or a cracked or leaky pipe. If you have any of these issues, it is important to call a professional plumber as soon as possible. They will be able to assess the problem, find the cause and make sure everything is working properly again.

Slow Draining

When a toilet is clogged it can cause a slow draining process. This can occur in sinks, showers, and bathtubs too.

First, you need to figure out what’s causing your slow draining problem. Then, you can use a plunger or a plumber’s snake to dislodge the clog and get your toilet running again.

The plunger works by creating a suction seal inside the toilet drain hole. You’ll need to make sure that you’re wearing rubber gloves and safety goggles when using this method, as the water can be corrosive.

Alternatively, you can use a drain snake to reach a clog that’s a long way down the pipe. This can work much better than a toilet brush.

You can also try pouring hot water into your drain pipe to loosen and break down a clog. This is particularly helpful for hardened drain buildup from grease, caulk, or wax products. It’s also good for removing soap residue and debris.

Overflowing Water

It’s a panic-inducing moment when your toilet overflows. Whether it’s in the middle of the night or during your lunch break, you aren’t happy to see water slowly pouring out of your toilet bowl onto the floor.

The first step in resolving an overflowing toilet is to stop the flow of water into your toilet by taking off the tank lid and pushing down the flapper. Next, turn off the water supply to your toilet.

A clogged drain line is the most common reason for an overflowing toilet, although there are other issues that can cause this problem. These include clogged vents, blocked sewer lines, and problems with your septic tank.

If you have any of these issues, it is likely best to call a plumber for help. A professional can fix these clogs and check for other clog causes that you might not be able to clean with a plunger. They can also recommend other solutions for your plumbing issues.

High Water Bills

If your water bill is suddenly higher than usual, there could be a number of issues that need to be resolved. For example, you may have a plumbing leak that is not visible to the naked eye.

This is the most common reason for high water bills and can occur in many different areas of your home. Leaks can waste gallons of water every day and raise your bill substantially.

The most common type of leak that causes this issue is a running toilet, especially when there is a faulty flapper at the bottom of the tank. This can cause a lot of water to be wasted when the toilet flushes.

It can also be caused by a water meter that is not reading accurately. There are a few steps you can take to check whether your water meter is working correctly and if it is, you should not use any water while the meter is being read.




Similar Posts